Breathe Life into Your Torn Jacket

How to Repair a Ripped Rain Jacket


How-to-Repair-a-Ripped-Rain-Jacket-gear-patrol-slide-1
How-to-Repair-a-Ripped-Rain-Jacket-gear-patrol-slide-2
How-to-Repair-a-Ripped-Rain-Jacket-gear-patrol-slide-3

Repairing a rip in your rain jacket can save you a ton of coin, and it’s better for the environment to keep a jacket’s worth of plastic out of the landfill. Plus, it’s dead simple. Thanks to brands like Gear Aid, even the least DIY-able person can repair a rain jacket in about 20 minutes.

1
Assess the damage. If it’s only small tear (about the size of a quarter), you’re in luck: This is much easier to repair, and chances are it will be a lasting fix. For a larger tear (bigger than a quarter), you still have a shot. Begin by cleaning up any loose fibers with a scissor.

Use this time to inspect the lining of your jacket. If the lining is peeling or delaminating, then chances are your jacket isn’t worth saving. If you can, take your jacket to a recycling center. Most Patagonia stores accept well-loved rain jackets and will recycle them. Also, keep an eye out for abrasions and high-wear areas on the face fabric of the jacket, as those will be locations of future repairs.

2
Make sure your jacket is clean. If you haven’t washed your jacket in a while, throw it in a washing machine. Not only does regularly washing your jacket with a specially formulated detergent prolong its lifespan, but it also gives you the opportunity to re-waterproof the jacket. (Some pointers on that front.)

3
Make the repair. For a large tear, consider using a needle and thread before patching or taping. If you aren’t any good at sewing, this is best left to the professionals. Take the jacket to a tailor or seamstress to have the tear stitched back together. This can help make for a stronger repair, but if you aren’t careful, you can further damage your jacket.

In most cases, though, using only Tenacious Tape is suitable. Depending on which type of tape you have — e.g., a roll or pre-cut patches — step three will be different:

For the roll: Roll out a piece that will cover the tear with about an inch of space on all sides. Cut the tape from the rest of the roll. Trim the corners and round it out into either a circle or an oval.

For the patches: Pull the patch out of its container. Measure to make sure it will overlap the tear by about an inch on all sides.

4
Apply the Tenacious Tape. Peel the backing from the Tenacious Tape and carefully apply it to the outer fabric of your jacket. As you press down, start in the center and work your way out. This will help to avoid air bubbles. Allow the patch to set for 24 hours before using.

5
Repeat steps 3 and 4 on the inside of the jacket. While not completely necessary for small tears, adding a patch on the inside of the jacket can help to seal out water completely and make for a lasting repair. For a larger tear, this step is mandatory. Once the inner patch is applied, allow it to set for 24 hours before using.

Steps two through four are also applicable to pinholes and small tears in down and synthetically insulated jackets.

Everything You Need

From hole to whole.
Tenacious Tape Roll by Gear Aid $5
Tenacious Tape Patches by Gear Aid $5
How to Re-Waterproof Your Jacket

Because a rain jacket that doesn’t bead water is just a windbreaker. Read the Story